Configuring No Auth authentication

To view this content in our official product documentation, click here.

Introduction

This page walks through the steps required to configure no auth authentication for a connector.

The Steps

Step 1\ Log in to the Patchworks dashboard and navigate to process flows > connectors & instances, where all of your installed connectors are shown. From here, access settings for the connector that you need to update with a new authentication method - for example:

 

If you're building a new connector, you can pick up these steps when you reach the **authentication** section of the connector builder.

Step 2\ Access authentication details:

 

Step 3\ Click the add new authentication method button:

 

Step 4\ Complete basic details for this authentication method - ensure that you set the authentication type to no auth (public) - for example:

 

Step 5\ You don't need to add any settings under authentication setup - although if you want users to provide variable values when they add instances for this connector, or pass in header/body content, etc. then you can update these tabs:

 

Step 6\ Save changes.